Saturday, 22 February 2014

Panzerjäger - closing the hull

I have attached the wheel wells to the inside of the lower hull, but had to do it in 2 steps. I glued the left ones in place, clamped up and reinforced with tape. A day later I did the right side. Its not that the fit is bad per se, but the parts need some persuasion to keep in their proper place.

It gives the model a very sturdy structure, which translates again into issues when joining the lower and upper halves. I would have needed a bench vice to get the parts to sit flush, but had to make do with what I could find.


The result is as good as it's gonna get. Some obvious gaping seams were filled with putty and are now left to dry.


No comments:

Post a Comment

Related Posts Plugin for WordPress, Blogger...